wiring diagram AUDI A4 1999 B5 / 1.G AWM Engine Camshaft Timing Control Workshop Manual
Page 4 of 7
15-95
If specified value is not attained:
If specified value is attained:
Checking power supply
Test requirements:
Electrical Wiring Diagrams, Troubleshooting & Component Locations
binder
Repair Manual, 1.8 Liter 4
-Cyl. 5V Turbo Fuel Injection & Ignition,
Engine Code(s): AWM, Repair Group 24
- Connect multimeter to valve to measure resistance.
Specified value: 10 to 18
- Replace solenoid valve for camshaft adjuster.
- Check power supply.
Fuse for solenoid valve for camshaft adjustment OK Fuel pump relay OK.
- Disconnect connector -arrow- from camshaft adjuster.
Pa
ge 4 of 7 Camshaft timin
g control, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.15.3
Page 5 of 7
15-96
If the LED does not light up:
Electrical Wiring Diagrams, Troubleshooting & Component Locations
binder
If the LED lights up: - Connect voltage tester VAG 1527 B as follows:Connector
contact
Measure to
1 Engine Ground
- Operate starter briefly.
LED should light up.
- Check wiring from contact 1 on connector via fuse to fuel pump relay
for open circuit:
- Correct open circuit, if necessary.
- Check actuation.
Pa
ge 5 of 7 Camshaft timin
g control, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.15.3